Tacstar Universal

Does a tacstar universal barrel shroud (heat shield) fit a mossberg 500a persuader?

I would like to know if it is difficult to fit on this particular shotgun. Also i would like to know if it starts to loosen after some shots? My shotgun is a Mossberg 500a persuader 20in barrel with blue finish. Does it look good on this gun?? Thx

Fits perfectly. It’s a five minute install job. I have them on three guns here.

They *can* slide without the barrel attach point to block them….you know what I mean….but you can prevent that with a couple of inches of electrical tape wrapped around the barrel right where you snug your screws down on the shroud. Tighten them up tight over the tape. It stays put. Barrel mounted rail mounts take tape the same way.

I have to say, they’re probably useful for heat shielding to *some* folks….I have never fired enough rounds fast enough through a shotgun that it mattered….but I love the look.

TacStar Industries Universal Barrel Mt: 1/2-3/41 Lt #1081112 $15.07 Universal Barrel Mount – 1/2-3/4″ barrel x 1″ lightManufacture ID: 1081112Universal barrel mount for lasersights and flashlight. Adjusts to fit a variety of barrel diameters. UMB-2 fits barrel diameters ranging from 1/2″ to 3/4″ and accepts lasers or flashlights with a 1″ diameter.Warranty: 1 year from date of purchase….

Tacstar Universal Barrel Shroud $27.00 TacStar Barrel Shroud Universal 1081171…

Tacstar Tactical Mount Universal Barrel Mount (UBM-2) 1/2 to 3/4-Inch Barrel x 1-Inch Light $11.99 TacStar Universal Barrel Mount, 1/2in to 3/4 Barrel x 1in Light…